1. GK420T Desktop Thermal Printer User Guide
  2. Getting Started
  3. Connecting your Printer to a Device
  4. Interface Cable Requirements
  5. Serial Communications
  6. EPL Y Command
  • GK420t Desktop Thermal Printer User Guide
EPL Y Command

EPL Y Command

Use the serial port setup (
Y
) command to change the communications settings on the printer.
  1. With the host computer set at the same communications settings as the printer, send the
    Y
     command to change the printer to the desired settings.
    The
    Y
     command does not support setting data Flow Control. Use the
    Xon/Xoff
     setting instead.
  2. Change the host computer settings to match the new printer settings.
Refer to the EPL Page Mode Programming Guide for more information about this command.