1. SM20 Integration Guide
  2. Installation
  3. Installing the SM20 Stand
  • SM20 Integration Guide
Installing the SM20 Stand
View content for :
Product:

Installing the
SM20
 Stand

You can install the
SM20
 stand on a vertical surface or tabletop.
  1. Use the template below to mark the mounting holes on your tabletop or vertical surface.
    You can print this template to use it as a guide. If you print this page, ensure the template measures 8 cm x 8 cm (3.15 x 3.15 in.).
    Template of the bottom of the stand shows measurements from outside edge to center of keyholes.
  2. Use your marks to drill two pilot holes in your surface.
    Drill shown aiming at spots marked from template.
  3. Affix two # 8 wood screws in the pilot holes. Leave a minimum of 2.1 mm (.08 in.) clearance between the surface and screw head.
    Screws shown in the place where you drilled holes.
  4. Hang the
    SM20
     stand on the wood screws.
    Stand's keyholes mounting on the screws.