1. ZD888 热敏桌面打印机用户指南
  2. Setup
  3. Media Types and Sensing
  4. Loading Roll Media - Final Steps for the Cutter Option Only
  • ZD888 Direct Thermal Desktop Printer User Guide
Loading Roll Media - Final Steps for the Cutter Option Only

Loading Roll Media - Final Steps for the Cutter Option Only

If your printer has the optional cutter module installed, use these instructions to completed the loading of the roll media.
  1. Thread the media through cutter’s media slot and pull it out the front of the printer.
  2. Close the printer. Press down until the cover snaps closed.
After loading the media, you may need a calibrate your printer for the media (see Running a SmartCal Media Calibration). The printer’s sensors must adjust to sense the label, the liner, and the distance between labels to operate properly.
If you calibrated the sensor for a certain type of media earlier and reload the same media (size, vendor, and batch) without any changes in the media type in between, simply press the
FEED
 (Advance) button one time to prepare the new media for printing.