• TC53e/TC53e-RFID/TC58e Product Reference Guide
Replacing the MicroSD Card
Replacing the MicroSD Card

Replacing the MicroSD Card

This section describes how to replace a microSD card.
Follow proper electrostatic discharge (ESD) precautions to avoid damaging the MicroSD card. Proper ESD precautions include, but are not limited to, working on an ESD mat and ensuring the operator is properly grounded.
Do not put any labels, asset tags, engravings, stickers, or other objects in the battery well. Doing so may compromise the intended performance of the device or accessories. Performance levels such as sealing [Ingress Protection (IP)], impact performance (drop and tumble), functionality, or temperature resistance could be affected.
  1. Press and hold the Power button until the menu displays.
  2. Touch
    Power off
    .
  3. If the hand strap is attached, slide the hand strap clip away from the bottom of the device and then lift.
  4. Press the two battery latches down.
    Pressing the battery latches down.
    Do not attempt to insert fingers under the latches when pulling on the battery. Damage to the latches may occur.
    Image of discouraging to insert fingers under the latches to lift up.
  5. While pressing the latches down, press the two latches in toward the center of the device. The latches must be pressed in completely to release the battery.
    Pressing battery latches in and down.
  6. Lift the battery from the device.
    Pressing battery latches in and down.
  7. Lift the access door.
    Removing the microSD cover from inside the device.
  8. Slide the microSD card holder door to the Open position and lift it.
  9. Remove the old microSD card and insert the new microSD card into the card holder, ensuring that the card slides into the holding tabs on each side of the door.
  10. Close the microSD card holder door and slide it to the Lock position.
  11. Reinstall the access door.
    Replacing the microSD cover from the device.
    The access door must be replaced and securely seated to ensure proper device sealing.
  12. From the back of the device, insert the battery, bottom first, into the battery compartment.
  13. Press the battery down until it snaps into place.
  14. Replace the hand strap, if required.
  15. Press and hold the Power button to turn on the device.