Open the printhead assembly by rotating the printhead-open lever upward.
Slide the media guide all the way out.
The printhead may be hot and could cause severe burns. Allow the printhead to cool.
From the media hanger (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
The cutter blade is sharp. Do NOT touch or rub the blade with your fingers.
Feed the media through the cutter.
Slide in the media guide until it just touches the edge of the media.
Does the media that you are using require ribbon for printing? If you are not sure, see Ribbon.