Event | Beeper | Power LED
| Device Status LED
| Decode LED
| Ethernet (xS20)
|
|---|---|---|---|---|---|
Power Up | |||||
Power up with Low Power | 
Low, Medium, High Tone |  Solid Red | - | - | |
Power up with Limited Power
(USB or 15W PoE) |
Low, Medium, High Tone |  Green (Slow Blink) | - | - | |
Power up with Full Power
(24V or 30W PoE) |
Low, Medium, High Tone | Solid Green | - | - | |
Job Error | 
Low, Low Tone | Solid Green | Solid Red | - | |
Device Maintenance | |||||
Factory Reset | 
Medium, Medium Tone | Solid Green | - | - | |
Firmware Operations | |||||
Firmware Update Start | - | Solid Green |  Continuous Red Flash (2hz) | - | |
Firmware Update Success | - | Solid Green | - | - | |
Firmware Update Fail | 
Low Tone | Solid Green | Continuous Red Flash (5hz) | - | |
Autotune Operations | |||||
AutoTune Start | 
Medium Tone | Solid Green | - |  Continuous Green (2Hz) | |
AutoTune Success | 
High Tone | Solid Green | - | Solid Green | |
AutoTune Fail |
Low Tone | Solid Green | - | Solid Red | |
Decode | |||||
Barcode Decode Start | - | Solid Green |  Solid Amber | - | |
Barcode Decode Success |
Medium Tone | Solid Green | - | - | |
Barcode Decode Failure | - | Solid Green | - | - | |
Parameter Programming | |||||
Parameter Entry Accepted | 
High, Low, High, Low Tone | - | Solid Green | - | |
Parameter Number Entry Expecting Barcodes | 
High, Low Tone | - | Solid Green | - | |
Parameter Entry Error | 
Low, High Tone | - | Solid Green | - | |
