Proper illumination improves detection capabilities in challenging lighting conditions.
To install the illumination system on the device, follow the steps below:
Place the gasket onto the camera.
Attach the Illumination PCB to the camera via the board-to-board connector and secure it with two screws. The recommended Torque is 6.9 kgf-cm (6.0 lbf-in) using the Torx T8 fasteners.
Place the filter onto the camera exit window, lining up the corner chamfer of the filter to the corner chamfer of the camera housing (if required).
Place the illumination plate assembly onto the camera.
Attach the top cover and secure it with four screws. The recommended Torque is 6.0 in-lbs using the Torx T8 fasteners.
