1. ZD611R Thermal Transfer RFID Printer
  2. Maintaining the Printer
  3. Sensor Cleaning
  • ZD611R RFID Link-OS™ Desktop Printer
Sensor Cleaning
View content for :
Product:

Sensor Cleaning

Removing dust (normally) cleans these sensors.
Dust can accumulate on the media sensors. Blow or gently brush dust away while a soft cloth.
Do not use an air compressor to remove dust. Compressors add moisture, fine grit, and lubricant which can contaminate the printer.
Adhesive particles and airborne substances can cover or coat the optical components in non-typical use media and operating environments.
  1. Clean the Movable Sensor’s window (1). Gently brush away dust or use a can of compressed air; if necessary, use a dry swab to brush away dust. If adhesives or other contaminants remain, use an alcohol moistened swab to break them up.
    Shows cleaning the movable sensor
  2. Use a dry swab to remove any residue that may be left from the first cleaning.
  3. Repeat steps 1 and 2 as required until all residue and streaks are removed from the sensor.
  4. Spray the Upper Web (Gap) Array Sensor (1) below the printhead with a can of compressed air. If necessary, use an alcohol moistened swab to break up adhesive or other non-dust contaminants. Use a dry swab to remove any residue that may be left from the first cleaning.
    Shows cleaning the upper array sensor under the sliding ribbon chassis.