This procedure guides you through attaching the power supply to a grounded power source and the printer.
Never operate the printer and power supply in an area where they can get wet. Serious personal injury could result!
Set up the printer so that you can handle the power cord easily if needed. Some processes for setup or troubleshooting issues may ask you to remove power. Separate the power cord from the power supply receptacle or AC electrical outlet to ensure that the printer cannot carry electrical current.
Connect power in this order.
Plug the power supply into the printer’s DC power receptacle.
Insert the AC power cord into the power supply.
Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-C13 connector are used at all times. These power cords must bear the country's relevant certification mark in which the product is being used.
Plug the other end of the AC power cord into an appropriate AC electrical outlet. the AC outlet end of the power cord’s plug type can vary by region.
The AC outlet end of the power cord’s plug type can vary by region.
The active power light will turn on (green) if power is ON at the AC outlet.
