Mounting the Wall Bracket

Drill holes and install anchors according to the template supplied with the bracket.

Install two screws to the bottom of the bracket. The screw heads should protrude 2.5 mm (0.01”) from the wall.

Align the mounting bracket’s bottom mounting key holes with the screws.

Hang the bracket on the screws.

Install two top screws.

Tighten all screws.

Assemble the cradle onto the bracket. See steps 7 through 11 on Installing the 10-Slot Cradle Rack.

Route cables and connect to power source.

Installer should ensure that all building codes are followed when connecting the power supplies to an AC power source.

While installing the brackets, power supplies and cables:

Use tie wraps to secure cables to the bracket and rails.

Coil cables wherever possible.

Route power cables along the rails.

Route inter-cradle cables to the side rails and then from the rails to the bracket.