Print > Label Position > Tear Line Offset

Set the position where the printer stops for tear-off label removal.

If necessary, shift the position of the media over the tear-off feature after printing.

Lower numbers move the media into the printer by the specified number of dots (the tear line moves closer to the edge of the label just printed)

Higher numbers move the media out of the printer (the tear line moves closer to the leading edge of the next label).

Accepted values: –120 to +120

Related ZPL command(s):

~TA

SGD command used:

media.printmode

Printer web page:

View and Modify Printer Settings

General Setup

Tear Off