Connection > Wired > Wired IP Protocol

Connection > Wired > Wired IP Protocol

The wired print server’s IP address can be set by you ("permanent") or be selected by the server ("dynamic"). When a dynamic option is chosen, this parameter specifies the method(s) by which the print server receives the IP address from the server.
For printers with Protected Mode enabled, you cannot modify this setting from the front panel. For more information, refer to the Zebra Link-OS PrintSecure Printer Administration Guide.
Wired IP Protocol
You must reset the print server to allow changes to the network settings to take effect. See Connection > Networks > Reset Network.
Accepted values: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP & BOOTP, PERMANENT
Related ZPL command(s):
^ND
SGD command used:
internal_wired.ip.protocol
Printer web page:
View and Modify Printer Settings
Network Communications Setup
TCP/IP Settings