Loading Roll Media for Cutter Models
Loading Roll Media for Cutter Models

Loading Roll Media for Cutter Models

If your printer has the optional cutter module installed, use these instructions to continue loading the roll media.
  1. Thread the media through cutter’s media slot and pull it out the front of the printer.
  2. Close the printer. Press down until the cover snaps closed.
You may need a calibrate your printer for the media. See Running a SmartCal Media Calibration. The printer’s sensors must adjust to sense the label, the liner, and the distance between labels to operate properly.
However, you do not have to recalibrate the printer's media sensors when you are loading the media with the same physical specifications (size, label type) and vendor/batch. If this is the case, just press
FEED
 (Advance) to ready the new media for printing.