ZT200 Series Industrial Printer User Guide

Power Cord Specifications

For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific, three‑conductor grounded plug configuration.

Depending on how your printer was ordered, a power cord may or may not be included. If one is not included or if the one included is not suitable for your requirements, refer to the following guidelines:

The overall cord length must be less than 9.8 ft. (3 m).

The cord must be rated for at least 10 A, 250 V.

The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic interference.

1	AC power plug for your country—This should bear the certification mark of at least one of the known international safety organizations.
2	3-conductor HAR cable or other cable approved for your country.
3	IEC 320 connector—This should bear the certification mark of at least one of the known international safety organizations.
4	Length ≦ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.