1. US Home Page
  2. US Home Page
  3. ZT210/ZT220/ZT230 Industrial Printer User Guide
  4. Specifications
  5. General Specifications
  6. Power Cord Specifications
  • ZT200 Series Industrial Printer User Guide
Power Cord Specifications

Power Cord Specifications

For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific, three‑conductor grounded plug configuration.
Depending on how your printer was ordered, a power cord may or may not be included. If one is not included or if the one included is not suitable for your requirements, refer to the following guidelines:
  • The overall cord length must be less than 9.8 ft. (3 m).
  • The cord must be rated for at least 10 A, 250 V.
  • The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic interference.
Power Cord Specifications
1
AC power plug for your country—This should bear the certification mark of at least one of the known international safety organizations.
2
3-conductor HAR cable or other cable approved for your country.
3
IEC 320 connector—This should bear the certification mark of at least one of the known international safety organizations.
4
Length ≦ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.
International Safety Organization Certification Symbols