An M.2 SSD comes pre-installed in the Zebra 4Sight XV7 unit’s M.2 M-key socket. This SSD comes pre-loaded with your software and licensing. You should make a backup of this SSD before replacing it.
To replace the M.2 SSD in the Zebra 4Sight XV7 unit, perform the following:
Unplug the power supply from your unit.
Remove the chassis cover.
Remove the screw that holds the M.2 SSD to the motherboard. The board will spring up at a 20 degree angle. Pull the board out at the same angle.
Slip the edge of the new M.2 SSD into the connector from which you removed the previous mass storage device. The connecting edge will fit neatly into the socket, leaving the board at a 20 degree angle from the motherboard.
Press the mass storage device down and attach it to the motherboard with the same screw you removed in step 3.
Once the SSD is seated, reassemble the case.
Reconnect the power to your unit.
Note that, the M.2 SSD will draw its power directly through the motherboard.
After your Zebra 4Sight XV7 boots, run the UEFI Setup program to verify that the SSD is identified correctly.
