RFID > RFID Program Position
RFID > RFID Program Position

RFID > RFID Program Position

Specify the appropriate value if the desired programming position (read/write position) is not achieved through RFID tag calibration.
Accepted values:
  • F0 to Fxxx (where xxx is the label length in millimeters or 999, whichever is less) — The printer feeds the label forward for the specified distance and then begins programming.
  • B0 to B30 — The printer back-feeds the label for the specified distance and then begins programming. To account for the back-feed, allow the empty media liner to extend out of the front of the printer when using a backward programming position.
Related ZPL command(s):
^RS
SGD command used:
rfid.position.program
Printer web page:
View and Modify Printer Settings
RFID Setup
PROGRAM POSITION