1. US Home Page
  2. Print Drop Go Assembly Guide
  3. Mounting the Printer
  4. Preparing the Base
  5. Power Supplies
  6. Installing the Power Supplies
  • Print Drop Go Assembly Guide
Installing the Power Supplies

Installing the Power Supplies

Install the power supplies in the base using the appropriate clamps and end-stops.
  1. (Optional) Swap the installed clamp if the clamp marking does not match the printer's power supply wattage.
  2. Turn the unit onto its side.
  3. Loosen the end-stop screws (2, 3) and clamp screws (1, 4).
    The clamp screws on the underside of the device.
  4. Position the power supply with the plug socket facing the rear of the base and the label facing down.
  5. Push the power supply firmly against the rear panel while pushing the power supply end-stop firmly against the power supply.
  6. Tighten all clamp and end-stop screws.
  7. Repeat steps 3–6 for the second power supply.
  8. Verify both power supplies are secure.