• PS20 Personal Shopper Product Reference Guide
Mounting the Three Slot Cradle on a Dispenser Wall
Mounting the Three Slot Cradle on a Dispenser Wall

Mounting the Three Slot Cradle on a Dispenser Wall

The cradle can be bolted to a dispenser wall or any supporting furniture using eight mounting holes. The back cover of the cradle has two access holes for routing power cables to/from a power supply unit or adjacent cradle.
DO NOT connect more than four cradles when is standard charging mode or three cradles when in fast charging mode to a single power supply unit/. DO NOT connect the power supply unit to a power outlet until all installation steps are completed.
This procedure is only an example installation of Three Slot Cradles in fast charging mode - high-density configuration.
  1. Use the wall mount template to plan and mark the screw locations on the dispenser wall.
  2. In all cradles, plug the power extension cable (p/n CBL-MC18-EXINT1-01) to free the connector on the left slot.
  3. Plug the interconnect cable (p/n 25-66431-01R) to free the connector on the right slot.
    Three Slot Cradle - Cable Connections
    1
    Interconnect Cable (p/n 25-66431-01R)
    2
    Cradle Interconnection Extension Cable (p/Interconnect Cable n CBL-MC18-EXINT1-01)
  4. On all of the back covers, knock out the stamped access hole(s).
    1
    Stamped Access Holes
  5. Route interconnect cables through access holes in back covers.
    Three Slot Cradle - Back Cover Cable Routes
  6. Secure the back cover of each cradle using six T10 Torx screws (supplied). Torque screws to 6 Kgf-cm (5.2 in-lb).
    Three Slot Cradle - Securing the Back Cover
  7. Insert the front cover removal tool into two slots, lever upwards and pull to remove front cover from cradle.
    Three Slot Cradle - Removing Front Cover
  8. Position the cradle on the dispenser wall and route all interconnect cables through the access holes in the dispenser wall.
  9. Fasten the cradle to the wall using eight screws (not supplied). Make sure to use additional wall mounting hardware, as needed, for safe mounting, according to the wall type.
    Three Slot Cradle - Fastening the Cradle to a Wall
  10. Insert tabs on upper side of front cover into slots on cradle and rotate cover down until it snaps into place.
    Three Slot Cradle - Connecting the Front Cover
  11. Plug Power Extension Cable (p/n CBL-MC18-EXINT1-01) to interconnect cable (p/n 25-66431-01R).
  12. Plug “Y” cable (CBL-DC-392A1-02) to Interconnect cables (p/n 25-66431-01R).
  13. Plug “Y” cable (CBL-DC-392A1-02) to power supply unit.
  14. Secure power supply unit (p/n PWR-BGA12V108W0WW) to the back of the dispenser wall.
  15. Connect the power cord to the power supply unit and to a 110/220 VAC outlet.
    1
    Power Extension Cable (p/n CBL-MC18-EXINT1-01)
    2
    Power Extension Cable (p/n CBL-MC18-EXINT1-01)
    3
    Interconnect Cable (p/n 25-66431-01R)
    4
    Cradle Interconnection Extension Cable (p/n CBL-MC18-EXINT1-01)
    5
    DC “Y” Charging Cable Long (CBL-DC-392A1-02)
    6
    Power Supply Unit (PWR-BGA12V108W0WW)
  16. Place the socket onto the cradle and secure the four screws.
  17. Place the socket cover onto the cradle and secure the two screws.