Loading Roll Media for Cutter Models

ZD200 Series Thermal Transfer Printer User Guide
About This Guide
- Notational Conventions
- Icon Conventions
Introduction
Printer Features
Controls and Indicators
- User Interface
Setup
Setup for Windows OS
Print Operations
Maintenance
Troubleshooting
Interface Connector Wiring
- Universal Serial Bus (USB) Interface
Dimensions
Media
- Thermal Media Types and Procurement
  - Determining Thermal Media Types
- Media and Print Specifications
  - Label Dispenser (Peeler) Specifications
  - Cutter Option Specifications
ZPL Configuration
Glossary

If your printer has the optional cutter module installed, use these instructions to load roll media.

Thread the media through cutter’s media slot and pull it out the front of the printer.

Close the printer. Press down until the cover snaps closed.

After loading the media, you may need a calibrate your printer for the media (see SmartCal Media Calibration). The printer’s sensors must adjust to sense the label, the liner, and the distance between labels to operate properly.

If you calibrated the sensor for a certain type of media earlier and reload the same media (size, vendor, and batch) without any changes in the media type in between, simply press the

FEED

(Advance) button one (1) time to prepare the new media for printing.