1. ZD200 Series Thermal Transfer Desktop Printer User Guide
  2. Interface Connector Wiring
  3. Universal Serial Bus (USB) Interface
  • ZD200 Series Thermal Transfer Printer User Guide
Universal Serial Bus (USB) Interface
View content for :
Product:

Universal Serial Bus (USB) Interface

This figure shows the cable wiring required to use the printer’s USB two interfaces.
When used with third-party cables, your printer requires USB cables—or USB cable packaging—that bears the Certified USB mark to guarantee USB 2.0 compliance. Visit usb.org for details.
Type A and Type B connectors require different pinouts.
USB A style connector pinouts (A in the image shown)
Pin 1 — Vbus (+5 VDC). (Pin 2 — D- (Data Signal, Negative Side)
Pin 3 — D+ (Data Signal, Positive Side)
Pin 4 — Shell (Shield/Drain Wire)
USB B style connector pinouts (B in the image shown)
Pin 1 — Vbus (Not Connected)
Pin 2 — D- (Data Signal, Negative Side)
Pin 3 — D+ (Data Signal, Positive Side)
Pin 4 — Shell (Shield/Drain Wire)
USB Host +5 VDC power source is shared with serial-port phantom power. It is limited to 0.5mA per USB Specification and with on-board current limiting. The maximum current available through the serial port and USB port should not exceed a total of 0.75 Amps.