1. ZD200 Series Thermal Transfer Desktop Printer User Guide
  2. Setup
  3. Media Types and Sensing
  4. Loading Roll Media for Cutter Models
  • ZD200 Series Thermal Transfer Printer User Guide
Loading Roll Media for Cutter Models

Loading Roll Media for Cutter Models

If your printer has the optional cutter module installed, use these instructions to load roll media.
  1. Thread the media through cutter’s media slot and pull it out the front of the printer.
  2. Close the printer. Press down until the cover snaps closed.
After loading the media, you may need a calibrate your printer for the media (see Running a SmartCal Media Calibration). The printer’s sensors must adjust to sense the label, the liner, and the distance between labels to operate properly.
If you calibrated the sensor for a certain type of media earlier and reload the same media (size, vendor, and batch) without any changes in the media type in between, simply press the
FEED
 (Advance) button one (1) time to prepare the new media for printing.