ZD200 Series Thermal Transfer Printer User Guide

Sending a ZPL Configuration Script to the Printer

Complete printer Wi-Fi server setup by sending the ZPL script to the printer through the port you selected in Configuring the Printer Using ZebraNet Bridge’s Connectivity Wizard. You may want to save the ZPL script and use it to restore the printer network configuration if the printer is reset to its factory defaults in the future. Saving the script will also allow you to quickly configure multiple printers if they need the same settings.

Verify that the printer is connected to the computer through the wired cable connection to the USB port.

If the printer is switched off, turn printer power ON.

In the Connectivity Wizard: Review and Send ZPL for Wireless window, click

Finish

.

The computer sends the ZPL script to the printer through the interface port. The Wireless Setup Wizard screen closes.

Turn printer power OFF and then back ON.

Observe the wireless status on the printer’s indicator lights to confirm that you have set up your printer for wireless connectivity.

At this point, you can save the ZPL script for later use with this printer and to configure other printers that may need the same network settings. To save the script:

In the Review and Send ZPL for Wireless window, highlight the script, right-click it, and select

Copy

.

Open a text editor such as Notepad and paste the script into the application.

Save the script.

Back in the Connectivity Wizard, you may click

Cancel

to exit the Wizard without sending the script to the printer at this time.

To configure either the same printer again (in case it was reset to its factory defaults) or to configure other printers with the same settings, send the saved ZPL script file to the printer through the connection of your choice as detailed in the prior steps in this procedure.