Attaching the Printer to a Power Source

Never operate the printer and power supply in an area where they can get wet. Serious personal injury could result!

Ensure the appropriate power cord with a three-prong plug and an IEC 60320-C13 connector are used at all times. These power cords must bear the relevant certification mark of the country in which the product is being used.

Set up your printer so that you can handle the power cord easily if needed. Some setup and troubleshooting tasks may ask you to turn printer power OFF. When the instructions call for turning printer power OFF, separate the power cord from the power supply receptacle or AC electrical outlet to ensure that the printer CANNOT carry electrical current.

Plug the power supply into the printer’s DC power receptacle.

Insert the AC power cord into the power supply.

Plug the other end of the AC power cord into an appropriate AC electrical outlet.

The AC outlet (plug) end of the power cord varies by region.

The active power light turns green if power is on at the AC outlet.