Modifying or Viewing Secured Features
View content for :
Product:

Modifying or Viewing Secured Features

Some features may be locked either by default or by choice, and you need to perform certain tasks before they can be viewed or modified.
EU RED
If you purchased your printer within European, Middle Eastern, or African (EMEA) countries on or after August 1, 2025, the printer comes with specific security features to meet the EU Radio Equipment Directive (RED) requirements. As part of the setup process, you must do the following before you can access the control panel parameters or modify certain settings using commands:
  • set a Protected Mode password and configure Protected Mode
  • set a front panel password/PIN to view the control panel parameters
For more information, go to zebra.com/asr or refer to the Zebra Link-OS PrintSecure Printer Administration Guide.
Protected Mode
For printers that already have Protected Mode set up, you need to enter the Protected Mode (admin) password to change certain settings on the printer. For more information, refer to the Zebra Link-OS PrintSecure Printer Administration Guide.
Front Panel Password/PIN
The front panel display can be locked, limiting access to the control panel parameters until the front panel password is entered. This value is initially undefined and must be set before it can be used.
For more information about the front panel password, refer to the Zebra Link-OS PrintSecure Printer Administration Guide.