Connecting to the Zebra Integrated Multifunction Light
Connecting to the Zebra Integrated Multifunction Light
Connect to the Zebra Integrated Multifunction Light using Aurora Focus.
The Standard model of the light does not support a laser aimer or beeper.
Select the scanner from the
View Devices
screen in Aurora Focus.
Navigate to the
General
tab and click the
Enable Multi-Feature Integrated Light
checkbox.
Select
Standard
or
Full-Featured Model
from the drop-down menu based on your configuration.
Click the
Enable Beeper
checkbox to configure
Beeper Volume
,
Tone
, and
Duration
.
Click the
Enable 360 LED Status Indicators
checkbox to receive feedback from the light upon a successful read.
Click the
Hold Until the Next Trigger
checkbox to keep the status LED illuminated (green or red) until the next job result is sent.
Configure the
Number of Flashes
and the
Time per Flash (ms)
from the drop-down menu to determine the frequency and duration of the flashes.
(Optional) Go to
GPIO Mapping
in
Device Settings
to configure the Pass/Fail output types.
OUT1 and OUT2 on the FS80 are reserved for the Zebra Integrated Multifunction Light. The light's output GPIO is configurable for Pass/Fail Output, making OUT2 on the device available for other uses.
(Optional) Click to configure output settings, such as
Pulse Width
or
Output Delay
, directly on the light.
Configure Pass/Fail output on the Zebra Integrated Multifunction Light using the
Connect
chevron while configuring settings for a specific job.
to configure output settings, such as 
