Pairing the Ring Scanner Using Bluetooth HID

Pairing the Ring Scanner Using Bluetooth HID

Pair the ring scanner with EM45 using HID.
  1. Ensure that Bluetooth is enabled on both devices.
  2. Ensure that the Bluetooth device to discover is in discoverable mode.
  3. Ensure that the two devices are within 10 m (32.8 ft) of one another.
  4. Place the Ring Scanner in HID mode. If the ring scanner is already in HID mode, skip to step 5.
    1. Remove the battery from the ring scanner.
    2. Press and hold
      Restore
      .
    3. Install the battery onto the Ring Scanner.
    4. Hold the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.
    5. Scan the barcode below to place the ring scanner in HID mode.
    RS6000 Bluetooth HID Barcode
    RS6000 Bluetooth HID Barcode
  5. Remove the battery from the ring scanner.
  6. Re-install the battery into the ring scanner.
  7. Swipe down from the Status bar to open the Quick Access panel and then tap Settings app..
  8. Tap
    Connected devices
    .
  9. Tap
    Pair new device
    . The device begins searching for discoverable Bluetooth devices in the area and displays them under
    Available devices
    .
  10. Scroll through the list and select the ring scanner.
    The device connects to the Ring Scanner and
    Connected
    displays below the device name. The Bluetooth device is added to the
    Paired devices
    list and a trusted (“paired”) connection is established.
    A notification displays on the Notification panel and the The letter A icon. icon displays in the Status bar.