1. TC52 Product Reference Guide
  2. Data Capture
  3. Pairing a Bluetooth Ring Scanner
  4. Pairing in HID Mode Using Near Field Communication
  • TC52 Touch Computer Product Reference Guide
Pairing in HID Mode Using Near Field Communication

Pairing in HID Mode Using Near Field Communication

The device provides the ability to pair the RS5100/RS6100 or RS6000 Ring Scanner in HID Mode using NFC.
RS5100/RS6100 or RS6000 Only.
  1. Ensure that NFC is enabled on the device.
  2. Ensure that Bluetooth is enabled on both devices.
  3. Place the Ring Scanner in Human Interface Device (HID) mode. If the Ring Scanner is already in HID mode, skip to step 6.
    1. Remove the battery from the Ring Scanner.
    2. Press and hold the Restore key.
    3. Install the battery onto the Ring Scanner.
    4. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.
    5. Scan the barcode below to place the Ring Scanner in HID mode.
      Bluetooth HID Barcode
  4. Remove the battery from the Ring Scanner.
  5. Re-install the battery into the Ring Scanner.
  6. Align the NFC icon on the Ring Scanner with the NFC icon on the device.
    pairing with RS6000
    1
    NFC logo
The Status LED blinks blue indicating that the Ring Scanner is attempting to establish a connection with the device. When a connection is established, the Status LED turns off and the Ring Scanner emits a single string of low/high beeps.
A notification appears on the device screen.
The icon appears in the Status bar.