Installing the Attached Power Supply Base Options
Installing the Attached Power Supply Base Options

Installing the Attached Power Supply Base Options

The power base is designed for quick installation using mounting screws (provided with the upgrade kit) and a Torx T10 wrench that you supply.
  1. Remove media rolls (if any) from the printer.
  2. Unplug the power supply cable from the back of the printer.
  3. Turn the printer over and align the power base to the bottom of the printer, making sure the printer power plug is oriented toward the back of the printer. The printer’s rubber feet should align with recesses on the top of the power base.
  4. Use the screws provided to attach the power base to the printer. Thermal Transfer printer models use four screws (A), and Direct Thermal printer models use three screws (B). Tighten the screws using the T10 wrench provided in the kit.
    A
    Thermal Transfer printers
    B
    Direct Thermal printers
  5. Insert the DC input power plug into the printer.
    1
    DC input power plug
    2
    DC input power plug
  6. Re-connect the AC power cord to the printer power base.