1. ZD421 and ZD621 Series Desktop Printers User Guide
  2. Install Hardware Options
  3. Media Handling Options
  4. Installing the Label Dispenser
  • ZD421 and ZD621 Desktop Printers User Guide
Installing the Label Dispenser

Installing the Label Dispenser

To install the label dispenser, you must remove the standard bezel and disconnect DC input power to the printer. See Removing the Standard Bezel.
  1. Place the label dispenser module and printer right side up with the top of the module 12.5 mm (0.5 in.) below the bottom of the top cover. Center and push the module into the front of the printer and slide it up until it stops.
  2. Turn the printer upside down, then use the Torx wrench to attach the module to the printer with the two supplied screws.
    For optimal printer performance, update the printer’s firmware after installing options or immediately after the printer’s initial setup. See Updating Printer Firmware.