The connectivity modules are easily installable without the use of tools.
The discharge of electrostatic energy that accumulates on the surface of the human body or other surfaces can damage or destroy the printhead or electronic components used in this device. You must observe static-safe procedures when working with the printhead or the electronic components.
Power Failure Recovery Mode Jumper (OFF by Default)
All printer connectivity modules have a power failure recovery jumper that is set to the OFF position by default.
When the jumper is set to ON, the printer automatically powers on when plugged into an active AC power source. See Setting the Power Failure Recovery Mode Jumper for instructions on activating this mode.
Power Failure Recovery Mode is available ONLY on printers that have a Printer Connectivity Module installed.
See also
POWER
Button — Power Failure Recovery Mode in Standard Interface Controls for information on the power ON/OFF behaviors when the jumper is set to ON.
