Sensor Setting | Description | |
|---|---|---|
Sensor Type | Select the media sensor that is appropriate for the media that you are using. The reflective sensor can be used with all media types. The transmissive sensor should be used only for simple gap media. | |
Accepted values: |
| |
Related ZPL command(s): | ^JS | |
SGD command used: | device.sensor_select | |
Printer web page: | ||
Label Sensor | Set the sensitivity of the label sensor. This value is set during sensor calibration. Do not change this setting unless you are told to do so by Zebra Technical Support or by an authorized service technician. | |
Accepted values: | 0 – 255 | |
SGD command used: | ezpl.label_sensor | |
Printer web page: | ||
Take Label | Set the intensity of the take label LED. This value is set during sensor calibration. Do not change this setting unless you are told to do so by Zebra Technical Support or by an authorized service technician. | |
Accepted values: | 0 – 255 | |
SGD command used: | ezpl.take_label | |
Printer web page: | ||
