The peel assembly, which is part of the Peel-Off and Liner Take-Up options, consists of several spring-loaded rollers to ensure the proper roller pressure. Clean the pinch roller and tear-off/peel-off bar if adhesive buildup begins to affect peel performance.
Do NOT use your left hand to assist in closing the Peel assembly. The top edge of the Peel roller/assembly could pinch your fingers.
If adhesive buildup affects peel-off performance, complete these steps:
Raise the media door.
Open the printhead assembly by rotating the printhead-open lever upward.
The printhead may be hot and could cause severe burns. Allow the printhead to cool.
Push down the peel-off mechanism release lever to open the peel assembly.
Remove any media liner to expose the pinch roller.
While manually rotating the pinch roller, clean it thoroughly with the swab from the Preventive Maintenance Kit (part number 47362). In place of the Preventive Maintenance Kit, you may use a clean swab dipped in 99.7% isopropyl alcohol. Allow the solvent to evaporate.
While manually rotating the platen roller, clean it thoroughly with the swab. Allow the solvent to evaporate.
Use the swab to remove excess adhesive from the tear-off/peel-off bar. Allow the solvent to evaporate.
Apply minimum force when cleaning the tear-off/peel-off bar. Excessive force can cause the tear-off/peel-off bar to bend, which could have a negative effect on peel performance.
Close the peel assembly using the peel-off mechanism release lever.
Use the peel release lever and your right hand to close the peel assembly. Do not use your left hand to assist in closing. The top edge of the peel roller/assembly could pinch your fingers.
Rotate the printhead-open lever downward until it locks the printhead in place.
Close the media door.
The printer is ready to operate.
Press
PAUSE
to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
