1. ZT400 Series Industrial Printer User Guide
  2. Printer Setup
  3. Loading the Media
  4. Using Tear-Off Mode
  • ZT400 Series Industrial Printer User Guide
Using Tear-Off Mode

Using Tear-Off Mode

  1. If you have not already done so, follow the instructions in the section Inserting the Media into the Printer.
  2. Open the printhead assembly by rotating the printhead-open lever upward.
  3. Slide the media guide all the way out.
    The printhead may be hot and could cause severe burns. Allow the printhead to cool.
  4. From the media hanger (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
  5. Slide in the media guide until it just touches the edge of the media.
  6. Does the media that you are using require ribbon for printing? If you are not sure, see Ribbon.
    If using...
    Then...
    Direct Thermal media (no ribbon needed)
    Proceed to the next step.
    Thermal Transfer media (ribbon needed)
    If you have not already done so, load ribbon in the printer. See Loading the Ribbon. Then proceed to the next step.
  7. Rotate the printhead-open lever downward until it locks the printhead in place.
  8. Close the media door.
  9. If you have not already done so, set the printer to TEAR OFF mode. See Selecting a Print Mode.
  10. Press
    PAUSE
     () to exit pause mode and enable printing.
    The printer may perform a label calibration or feed a label, depending on your settings.
  11. For best results, calibrate the printer. See Calibrating the Ribbon and Media Sensors.
  12. Verify that your printer is able to print a configuration label by holding both the
    FEED
     and
    CANCEL
     keys for 2 seconds.