1. KC50 Product Reference Guide
  2. Getting Started
  3. Setting up the Device
  4. Connecting an Ethernet Power Supply and Powering on the Device
  • Kiosk Computer Product Reference Guide
Connecting an Ethernet Power Supply and Powering on the Device

Connecting an Ethernet Power Supply and Powering on the Device

The KC50 Kiosk Computer requires an external power supply. Connect an Ethernet cable to power the device.
Ensure your network provides enough energy to power the device. Refer to the PoE-capable network switch or power injector configuration guide and the Power over Ethernet section for more information.
If you are using a Zebra stand, refer to the KC50 Stand Installation Guide to connect the power supply.
  1. Insert the MC18 removal tool (sold separately) into the slot in the back cover to remove the cover from the device.
    remove cover
  2. Connect the Ethernet cable to the Ethernet port of the device (1).
  3. Connect the Ethernet cable to the PoE accessory (2).
    Inserting Ethernet cable into ethernet port
    The PoE accessory must be Class 4 or higher 802.3at/bt compliant Power Sourcing Equipment (PSE). The device turns on when it successfully negotiates with the PSE.
    Avoid excessive disconnecting/reconnecting the RJ45 on a PoE system to minimize electrical arcing on the RJ45 connector.
  4. Place the cover back onto the device and press firmly until it clicks into place.
    Replacing back cover.
The device is ready for use.