Print Setting | Description | |
|---|---|---|
Darkness | Set the darkness to the lowest setting that provides good print quality. If you set darkness too high, the label image may print unclearly, bar codes may not scan correctly, or the printhead may wear prematurely. SGD: print.tone_zpl |  |
Print Speed | Select the speed for printing a label (given in inches per second). Slower print speeds typically yield better print quality. SGD: media.speed |  |
Media Type | Select the type of media that you are using. SGD: ezpl.media_type |  |
Tear Off | If necessary, adjust the position of the media over the tear bar after printing. SGD: ezpl.tear_off |  |
Print Width | Specify the width of the labels being used. The default value is the maximum width for the printer based on the printhead’s DPI value. SGD: ezpl.print_width |  |
Print Mode | Select a print mode that is compatible with your printer options. SGD: ezpl.print_mode |  |
Label Top | If necessary, shift the position of the image vertically on the label.
SGD: zpl.label_top |  |
Left Position | If necessary, shift the print position horizontally on the label. Positive numbers move the left edge of the image toward the center of the label by the number of dots selected, while negative numbers move the left edge of the image toward the left edge of the label. SGD: zpl.left_position |  |
Reprint Mode | When reprint mode is enabled, you can reprint the last label printed either by issuing certain commands or by pressing the DOWN ARROW on the keypad. SGD: ezpl.reprint_mode |  |
Label Length Max | Set the maximum label length to a value that is at least 25.4 mm (1 in.) greater than the actual label length plus the interlabel gap. If you set the value to one that is smaller than the label length, the printer assumes that continuous media is loaded, and the printer cannot calibrate. SGD: ezpl.label_length_max |  |
Language | If necessary, change the language that the printer displays. |  |
To facilitate easier selection, the available options for this parameter are displayed in the language you can read. | ||
