Loading Media in Peel-Off Mode (ZQ610 Plus/ZQ620 Plus)

This section describes loading media into the ZQ610 Plus and ZQ620 Plus printers in Peel-Off Mode.

Peel a few labels off the backing.

Open the printer.

Press the latch release button (1) on the side of the printer.

The media cover releases.

Rotate the media cover (2) backward completely, exposing the media compartment and adjustable media supports.

Pull the media supports apart and insert the roll of media between the supports in the orientation shown.

Push the peeler lever up to release the peeler bail into the up position.

The media feeds toward the peeler bail.

Close the media cover.

The peeler bail folds down. The printer is now primed to remove labels from the roll automatically.

Press

POWER

to turn on the device, or press

FEED

if the device is already on.

The printer advances the media to the next label if printing labels. If you print on journal media, the printer advances a short strip of media.

Disengaging the Peeler Bail

To disengage the peeler bail:

Open the media cover as previously described. The peeler bail automatically pops up.

Push the peeler bail down until it locks into place.

Close the media cover.