Waist Holster

Unsnap the fastener on the waist strap.

Unlock the male D swivel clip on the waist strap from the female D clip on the printer mount pad to remove it.

Align the holes on the mount pad with the mounting holes on the bottom of the printer (circled).

Use a 4mm hex driver on the two 6-32 x 0.375 in. screws and two #6 washers to attach the mount pad to the top of the printer (circled).

Attach the two 6-32 x 0.625 in. screws and washers to the bottom of the mount pad (circled).

Connect the male D swivel clip on the waist strap to the female D clip on the printer mount pad.

Snap the fasteners to secure (opposite side), and then rotate the waist strap 180°.

Unsnap the waist strap and adjust it to the desired length.

Wrap the waist strap around your waist and snap the fastener in place to secure it.