1. 123RFID Desktop User Guide
  2. Application Features
  3. Online Reader Configuration
  4. Communication Settings
  5. End Point Configuration
  • 123RFID Desktop
End Point Configuration

End Point Configuration

Create, update, or delete an end point configuration for device management using SOTI and MDM.
This feature is available for handheld readers only.
  1. To add a new end point configuration, click
    New
    , enter the values and click
    Add
     to save the values.
  2. Create a new end point by providing the following information:
    RFD40 End Point Configuration
    • Type
       - select the end point type.
    • Protocol
       - select the protocol type.
    • URL
       - provide the end point destination URL.
    • Port
       - enter the port number of the connection.
    • Keep Alive
       - enter the duration (s) to buffer messages when the connection is lost.
    • Tenant ID
       - enter the tenant ID.
    • Clean Session
       - enable or disable cleaning the session data of the connection.
    • Reconnect Delay
       - enter the minimum and maximum seconds before attempting to reconnect.
    • Host Verify
       - enable or disable verifying that the hostname in the certificate is valid for the host.
    • User name
       - enter the Basic Authentication user name, if required.
    • Password
       - enter the Basic Authentication password, if required
    • CA Certificate
       - select and add the CA Certificate.
    • Client Certificate
       - select and add the Client Certificate.
    • Private Key
       - select and add the Private key.
    • Command Topic
       - enter the basic Command topic.
    • Response Topic
       - enter the basic Response topic.
    • Event Topic
       - enter the basic Event topic.
    The
    End point configurations list
     shows all existing end point configurations. User can select an end point configuration to update.
  3. Click
    Save
     to save the selected configuration, or
    Cancel
     to cancel the current operation.
  4. Click
    Delete
     to delete the selected configuration, or
    Delete All
     to delete all existing configurations.
The default end point configuration appears on the application if there is no existing end point configuration.