The 3-in-1 wide base can serve as a wall mount, enabling the device to be mounted to a wall.
Remove the wide base from the 3-in-1 multi-mount. For more information, go to Removing the Wide Base.
Mark the location on the wall where the wide base will be installed.
Mount the scanner no more than 2 m (6 ft 5 in.) above the floor.
Install the cable into the wide base.
Use the straight cable when the device is wall-mounted.
Position the cable connector through the top D-Cutout (1) located next to the wide base screw.
Run the cable downward along the edge of the wide base and out the D-Cutout (2) on the opposite end.
With the cable installed, hold the wide base to the predetermined location on the wall, and then insert and tighten #6 wood screws (not provided) through each screw hole in the wide base.
Pivot and slot (1) the narrow base into the (2) notch of the wide base, and then fully insert the narrow base into the wide base.
Using a Philips-head screwdriver, tighten the wide base screw to fasten the narrow base to the wide base.
Connect the power cable to the scanner, and then mount the scanner onto the top swivel plate.
