Replacing the Hand Strap

This section provides information for installing the hand strap onto the expansion back.

If the Power Pack is installed, remove the Power Pack.

Rotate the disk so that the strap end without the eyelet is aligned with the Power Pack opening.

Open both ends of the hand strap.

Pull the strap end without the eyelet through the slot on the Expansion Back.

Rotate the disk 180°.

Slide the pad off the hand strap.

Pull the eyelet (1) end through the slot (2) on the Expansion Back.

Remove pad from new replacement hand strap.

Rotate the disk (6) so that one of the slots is aligned with the Power Pack opening (7).

Feed the new hand strap through the slot (3) at the Power Pack opening (7).

Slide pad (1) onto hand strap with the stylus holder (2) facing up.

Fold the eyelet end of the strap up and press hook and loop material together.

Rotate disk 180° so that the empty slot is aligned with the Power Pack opening.

Feed strap through the slot.

Fold the end of the strap up and press hook and loop material together.