Replacing the ZD611D Printhead
Replacing the ZD611D Printhead
View content for :
Product:

Replacing the
ZD611D
Printhead

This procedure guides you through replacing the printhead.
Read this procedure first before you begin your repair.
  • Turn the printer OFF.
  • Open the printer to gain access to the printhead (1).
The printhead becomes hot while printing. To protect from damaging the printhead and risk of personal injury, avoid touching the printhead. Only use the cleaning pen to perform printhead maintenance.
The discharge of electrostatic energy that accumulates on the surface of the human body or other surfaces can damage or destroy the printhead and other electronic components used in this device. You must observe static-safe procedures when working with the printhead or the electronic components under the top cover.
Shows the printhead with its ESD and Hot Surface warnings
  1. Push the printhead release latch away from the printhead. The right side of printhead releases.
    Shows the printhead release latch pulls to the right to release.
  2. Swing the loose right side of the printhead out of the printer. Pull it out and to the right a little to get the left side of the printhead clear. Pull the printhead out and free of the top cover to gain access to its attached cables on the backside of the printhead. Note, the redline highlights the left side printhead retainer slot.
    Shows the printhead released and swinging out.
  3. Gently but firmly pull the two printhead cable bundle connectors (1) off of the printhead (2). Pull the ground wire (3) off the printhead.
    Shows the printhead released and swinging out.
  4. Align the printhead up to the printer. Push the right-side printhead cable connector into the printhead. The connector is keyed to only insert one way.
  5. Attach the ground wire to the printhead’s ground tab.
  6. Push the left side printhead cable connector onto the printhead
    Shows the new printhead being connected to the cables and ground.
    1 – Connector with Key
    2 – Printhead Ground Wire
    3 – Spring Wire Notch
    4 – Printhead Ground Tab
  7. Insert the left side of the printhead assembly into the recessed slot (1) highlighted in red on the left side of the printer.
    Shows the new printhead being connected to the cables and ground.
  8. Align the spring wire notch (1) on the backside of the printhead to the spring wire. Push the right side of the printhead into the printer until the latch locks the right side of the printhead into the printer.
    Shows the new printhead being connected to the cables and ground.
  9. Verify that the printhead moves up and down freely when pressure is applied and remains locked when released.
    Shows the new printhead being connected to the cables and ground.
  1. Clean the printhead. Use a new pen to wipe body oils (fingerprints) and debris off the printhead. Clean from the center of the printhead to the outside. See Cleaning the ZD611D Printhead.
  2. Plugin the printer power is disconnected.
  3. Load full-width label or receipt paper roll. Printing with a full-width roll verifies all elements of the printhead function.
  4. Print a Configuration Report. See Print a Configuration Report to Test Printing.