Pairing in HID Mode Using Near Field Communication
Pairing in HID Mode Using Near Field Communication
The device provides the ability to pair the RS5100 or RS6000 Ring Scanner in HID Mode using NFC.
Ensure that NFC is enabled on the device.
Ensure that Bluetooth is enabled on both devices.
Ensure that the Bluetooth device to discover is in discoverable mode.
Ensure that the two devices are within 10 meters (32.8 feet) of one another.
Place the Ring Scanner in Human Interface Device (HID) mode. If the Ring Scanner is already in HID mode, skip to step 6.
Remove the battery from the Ring Scanner.
Press and hold the Restore key.
Install the battery onto the Ring Scanner.
Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.
Scan the barcode below to place the Ring Scanner in HID mode.
Remove the battery from the Ring Scanner.
Re-install the battery into the Ring Scanner.
Align the NFC icon on the Ring Scanner with the NFC icon on the device.
1
NFC logo scanner
2
NFC antenna area
The Status LED blinks blue indicating that the Ring Scanner is attempting to establish a connection with the device. When a connection is established, the Status LED turns off and the Ring Scanner emits a single string of low/high beeps.