Easily attach the printer power base to the printer to organize your work area.
Remove any media rolls from the printer.
Remove the DC power cable from the back of the printer.
Remove any attached printer interface cables.
The power base is ready to attach to the printer.
The base is installed using a #10 hexolobular driver.
The direct thermal printer models attach to the printer with three screws.
The thermal transfer printer models attach to the printer with four screws.
Turn the printer over and align the power base to the bottom of the printer. The power base's power plug is oriented toward the rear of the printer. The printer’s rubber feet align with recesses at the top of the power base.
Use the screws provided to attach the power base to the printer.
3 screws for Direct Thermal printers.
4 screws for thermal Transfer printers.
Tighten the screws using the #10 hexolobular wrench.
Attach the DCpower plug on the power base to the printer's DC power receptacle.
1 – DC Input Power Plug
2 – AC Power Cord
Re-connect the AC power cord to the printer power base.
