Adjusting the Toggle Position

Adjusting the Toggle Position

If the toggles are not positioned correctly or adjusted to apply the correct pressure, you may see issues while printing. Use these steps to adjust the toggle position.
For details on the circumstances in which the toggle pressure may need adjusting, see Adjusting the Printhead Pressure, Toggle Position, and Balance.
  1. Open the printhead assembly to lessen the pressure on the toggles.
    Open the printhead assembly
  2. Loosen the locking nut at the top of the toggle you want to move.
    Loosen the toggle locking nut
  3. Reposition the toggle as necessary to provide even pressure on the media.
    Reposition the toggle
    For media this size...
    Position the toggles this way
    less than 40 mm wide
    Left toggle centered. No pressure on right toggle.
    Toggle position for narrowest media
    40 mm to 51 mm wide
    Option 1
    Left toggle centered. No pressure on right toggle.
    Toggle position option 1 for medium width media
    40 mm to 51 mm wide
    Option 2
    Equal distances from each other and from both edges of the media.
    Toggle position option 2 for medium width media
    larger media widths
    25.4 mm (1 in.) from both edges of the media.Toggle position for wider media
    1
    left toggle
    2
    right toggle
    3
    media
    4
    platen roller
  4. Tighten the locking nut.
    Tighten the toggle locking nut