Follow the instructions in this section to load media in Tear Off mode on a ZT610 printer with the 600 dpi micro-label option. In this mode, each label or batch of labels is torn off from the media roll after printing.
Rotate the media guide adjustment knob to fully extend the guide.
For most media, retract the extender on the media guide (1). For very narrow widths, expand it (2).
The printhead may be hot and could cause severe burns. Allow the printhead to cool.
From the media spindle (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
Guide the media under the front media sensor (1).
Rotate the media guide adjustment knob as shown until the media guide just touches the edge of the media.
