Follow the instructions in this section to load media in Peel Off mode on a ZT610 printer with the 600 dpi micro-label option. In this mode, the labels peel from the media liner as they pass over the peel roller, and the printer stops after each label. Remove the label presented to move to the next one.
Rotate the media guide adjustment knob to fully extend the guide.
For most media, retract the extender on the media guide (1). For very narrow widths, expand it (2).
The printhead may be hot and could cause severe burns. Allow the printhead to cool.
From the media spindle (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
Guide the media under the front media sensor (1).
Extend approximately 24 in. (610 mm) of media out of the printer. Remove and discard the labels from this exposed media, leaving just the liner.
Guide the media liner behind the peel rod.
Remove the hook from the rewind spindle.
Open the rewind pinch roller assembly.
Thread the liner between the rollers in the rewind pinch roller assembly, and then wind the liner around the rewind spindle.
Rotate the rewind spindle to create tension on the liner.
Locate the slot on the edge of the rewind spindle.
To secure the liner in place, insert the long end of the spindle hook into the small hole on the rewind spindle guide plate and the short end into the hole in the center of the adjusting nut.
Close the rewind pinch roller assembly.
Align the groove on the media holder with the ribs on the rewind spindle.
Push the media holder inward until it just touches the liner.
Tighten the screw on the media holder.
Rotate the media guide adjustment knob as shown until the media guide just touches the edge of the media.
