Follow the instructions in this section to load media in Rewind mode on a ZT610 printer with the 600 dpi micro-label option. In this mode, the media winds onto a core on the rewind spindle after the labels are printed.
Rotate the media guide adjustment knob to fully extend the guide.
For most media, retract the extender on the media guide (1). For very narrow widths, expand it (2).
Open the rewind pinch roller assembly.
Slide a core onto the rewind spindle until it is flush against the guide plate.
The printhead may be hot and could cause severe burns. Allow the printhead to cool.
From the media spindle (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
Guide the media under the front media sensor (1).
Guide the media over the rewind plate and thread it into the printer base.
Thread the media between the rollers in the rewind pinch roller assembly, and then wind the media around the rewind spindle. Rotate the rewind spindle several turns to tighten the media and remove any slack.
Close the rewind pinch roller assembly.
Align the groove on the media holder with the ribs on the rewind spindle.
Push the media holder inward until it just touches the media.
Tighten the screw on the media holder.
Rotate the media guide adjustment knob as shown until the media guide just touches the edge of the media.
