1. ZT610/ZT620 Industrial Printer with Color Touch Display User Guide
  2. ZT610 600 dpi Micro Label Printer
  3. Preparing the Printer for Precision Printing
  4. Installing the Peel Plate
  • ZT610/ZT620 Industrial Printer with Color Touch Display User Guide
Installing the Peel Plate

Installing the Peel Plate

Use this procedure to install the peel plate for Peel mode.
  1. If the rewind plate is installed, remove it from the printer.
    1. Slide the rewind plate to the right to disengage the top.
      Slide the rewind plate to the right
    2. Rotate the rewind plate to disengage the tabs on the bottom, and remove the plate from the printer.
      Rotate and remove the rewind plate
  2. Loosen the peel plate mounting screw.
    Loosen the screw
  3. Slide the slot of the peel plate onto the screw.
    Slide the peel plate onto the screw
  4. Slip the hole on the right side of the peel plate over the projection on the tear bar plate.
    Mount the hole onto the projection on the tear bar plate
  5. Tighten the peel plate mounting screw.
    Tighten the screw