Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
FS80 Fixed Industrial Scanner Product Reference Guide
Hardware Installation
Mounting the Device
FS80 Fixed Industrial Scanner Product Reference Guide
FS80 Fixed Industrial Scanner Product Reference Guide
About this Guide
Configurations
Zebra Integrated Multifunction Light and Lens Compatibility
Accessories
Notational Conventions
Icon Conventions
Service Information
Getting Started
Unpacking the Device
Hardware Installation
Mounting the Device
Connecting the Device
Installing a C-Mount Lens
Electrical Installation
IO Specification
Integrating Auxiliary Interfaces and Signals
Connecting to the Auxiliary IO Interface
Auxiliary Output Signal Connections
Connecting Devices to the Auxiliary Output Signals
Optically Isolated Output Signals
Connecting to Third-Party Devices
Connecting an Auxilary Output Signal to a Sourcing Input
Connecting an Auxiliary Output Signal to a Sinking Input
Connecting to a Sinking Input Using an External Pull Up Resistor
Connecting an Auxiliary Output Signal to an Inductive Load Input
Auxiliary Input Signal Connections
Connecting Devices to the Auxiliary Input Signals
Adding Pull Up Circuitry
Connecting an External Bleeding Resistor
Connecting a Sourcing Output Device to an Auxiliary Input Signal
Connecting a Sinking Output Device to an Auxiliary Input Signal
Connecting a 3-Wire PNP Proximity Sensor
Connecting a 3-Wire NPN Proximity Sensor
Connecting a 2-wire Proximity Sensor
Using the Device
LED Indicators
Updating the Device Firmware
Connecting to the Zebra Integrated Multifunction Light
Maintenance
Known Harmful Ingredients
Approved Cleaning Agents
Tolerable Industrial Fluids and Chemicals
Technical Reference
Specifications
Dimensional Drawings
Connector Diagrams
Digital IO and Power Cable
Power and IO Y Cable
Ethernet Connector
Reading Diagrams
Mounting the Device
Mounting the Device
If you are using the scanner in a deployment environment, fasten it to a support using its provided mounting holes.
For the dimensions of the mounting holes, go to the
Dimensional Drawings
.
Hardware Installation
